Englishla angla
phone
Telefono:0312-3189593

TESTING KNOWLEDGE · OIL ANALYSIS

Specify the Test Before Comparing Oil Acidity Results

A request for an “oil acidity test” can be ambiguous. Water-soluble acid determination and acid number testing address different analytical questions. Identifying the required method prevents confusion when ordering equipment, requesting laboratory analysis, or reviewing a report.

Identify the Required Measurement

GB/T 7598 addresses water-soluble acid determination in transformer oils in service. The full method should govern sample preparation, measurement, and reporting. Reference: official GB/T 7598 listing.

Acid number testing is a separate analysis. ASTM D664 describes potentiometric titration for acidic constituents in applicable petroleum products and related materials. Acid number is expressed in milligrams of potassium hydroxide per gram of sample, under the conditions of the method. Reference: ASTM D664.

The method must also be suitable for the particular sample and specification. A familiar standard number should not be selected without checking its applicability.

Why the Results Are Not Interchangeable

A pH result reported for a water-soluble acid assessment is not an acid number. Do not relabel it as mg KOH/g or convert it using an assumed universal formula.

Similarly, an acid number result should not be presented as the result of a separate water-soluble acid test. Keep the test name, method, and reporting basis together.

Review PointWater-Soluble Acid TestAcid Number Test
Example referenceGB/T 7598 for transformer oils in serviceASTM D664 where applicable
Reporting checkConfirm the prescribed result format, including any pH-based reporting.Retain the acid number and mg KOH/g units.
Comparison ruleDo not substitute one result for the other or assume a direct conversion.

Avoid Turning One Indicator into a Complete Diagnosis

ASTM D664 cautions that acid number does not provide a general prediction of an oil’s corrosiveness under service conditions. A result should therefore be interpreted within the relevant specification and assessment process.

As a practical reporting approach, record what was measured, the required limit or comparison basis, and any follow-up action. Avoid replacing that explanation with a broad statement that the oil is universally “good” or “bad.”

Before requesting a quotation: Provide the exact test name, method, sample type, and expected reporting format. “Acidity tester” alone may not identify the instrument you need.

Frequently Asked Questions

Can one test automatically replace the other?

No. Use the analysis required by the applicable specification. Any proposed substitution needs an appropriate technical basis and acceptance by the responsible party.

Can results from different acid-number methods always be compared directly?

Do not assume numerical equivalence. ASTM D664 notes that its results may differ from those obtained by other acid-number methods. Retain the method reference in every comparison.

Match the Instrument to the Required Analysis

Share your test method, sample type, reporting requirements, and daily workload with Baoding Push Electrical Manufacturing Co., Ltd. when discussing oil analysis equipment.

Se vi interesiĝas pri niaj produktoj, vi povas elekti lasi viajn informojn ĉi tie, kaj ni baldaŭ kontaktos vin.